Building on acreage outside Abilene, replacing a played-out old well, or getting off a hauled-water or shared-well situation? Abilene Water Well drills new water wells across Abilene and the Big Country, completed to Texas standards and ready to deliver water — casing, pump, pressure tank, and electrical, not just a hole in the ground.
What’s Included
- New residential & rural domestic wells
- Livestock, irrigation & property wells
- Casing, grouting & well completion to TX code
- Pump, pressure tank & electrical hookup
- Free site assessment & written estimate
Drilled for the Aquifer Under Your Property
Taylor County and the counties around it draw from the Edwards-Trinity and Trinity aquifer system, and depth to good water varies a lot across the area — some wells come in shallow, others have to reach deeper Trinity sands. We assess your site, target the right producing zone, and case and grout the well to protect your water from surface contamination, exactly as state rules require.
Because ground conditions and depth are the two biggest cost drivers, we quote your well in writing after we look at the site rather than throwing out a per-foot number that balloons later. National guides put a complete Texas residential well anywhere from roughly $9,000 to $25,000 depending on depth and the full system — we'll give you an itemized figure for your property, not a range off the internet.
- Site assessment & target-zone selection
- Steel or PVC casing, sized to the well
- Sanitary grouting & surface seal to TX code
- Complete system: pump, pressure tank, wiring
One Company From the Hole to the Tap
We don't drill the well and leave you to find a pump company. We complete the whole system — set the pump, plumb the pressure tank, wire the controls, and get water to the house — so there's one licensed company standing behind the entire job. We also register the well as the state requires, so your paperwork is right if you ever sell.