Serving Abilene, TX & nearby Mon–Sat 7am–7pm
TDLR-Licensed Well Driller & Pump Installer · Insured · Free Estimates

Well Pump Repair & Replacement in Abilene, TX

Fast diagnosis and repair when your well pump quits — submersible, jet, and pressure problems across the Abilene area.

technician repairing a well pump and pipework near Abilene, TX

No water at the tap, air spitting from the faucets, a pump that won't shut off, or a breaker that keeps tripping — that's when most Abilene well owners call us, and it's usually not a wait-and-see situation. Abilene Water Well does well pump repair and replacement across Abilene and the surrounding counties, and we schedule most calls within the same week and plenty of them the same day.

What’s Included

  • Same-week (often same-day) service calls
  • Submersible & jet pump replacement
  • Pressure switch, control box & wiring repair
  • Pulling, inspecting & re-setting the pump and drop pipe
  • Motor, wiring & short-cycling diagnosis

We Find the Real Problem Before We Sell You a Pump

A dead well doesn't always mean a dead pump. We've pulled plenty of "bad pumps" that turned out to be a burned pressure switch, a failed control box, a nicked wire, a waterlogged pressure tank, or a dropped water level after a dry stretch. We test the system top to bottom — pressure, amperage, wiring, and the water level in the casing — and tell you what's actually wrong and what it costs before we start pulling pipe.

When the pump does need to come out, we pull it, inspect the motor, drop pipe, wiring, and pitless adapter, and show you what failed. If it's a full replacement we size the new pump to your well's depth and yield — an oversized pump in a modest West Texas well just burns itself out short-cycling — and set it back with new wire and torque-arrestors so it lasts.

  • Submersible pump pull, inspection & replacement
  • Jet pump and above-ground system repair
  • Pressure switch, control box & capacitor replacement
  • Drop pipe, wiring, and pitless adapter repair
  • Short-cycling, low-pressure & air-in-line diagnosis

Sized and Set for a West Texas Well

Abilene-area wells aren't shallow East Texas wells. Deeper static levels and hard, mineral-heavy water are hard on pumps, and a pump that was fine twenty years ago may be wrong for the well today. We match pump horsepower and flow to your actual depth and recovery rate, so you get steady pressure without cavitation or constant cycling — and a system that isn't fighting the aquifer.

We stock and install the common submersible sizes so most repairs finish the same visit, and we leave you with an itemized invoice showing exactly what went in the hole.

Well Pump Repair & Replacement Questions, Answered

Why do I suddenly have no water from my well?
The most common causes are a failed pump or motor, a tripped or failed pressure switch or control box, a waterlogged pressure tank, or a drop in the well's water level. We diagnose which it is before recommending any replacement, so you're not paying for a pump you didn't need.
How long does a well pump last near Abilene?
A properly sized submersible pump usually lasts well over a decade, but hard water, sand, and short-cycling from a bad pressure tank or oversized pump can shorten that. When we replace one, we size it to your well so it isn't working against itself.
Can you come out the same day?
We schedule most pump calls within the same week and many the same day, because a house with no water can't wait. Call us and we'll tell you honestly when we can be there.

Get Your Free Well Pump Repair & Replacement Quote

No water, or planning a new well in Abilene?

Call now or request a free quote — most estimates scheduled within 24 hours.